Home What's New Building the Daylight Daylight Tender Observation Car Engine Stand Gondolas Gauge Bell Ringer Air Pump Gas Switcher Taffy Puller

#12 Cylinders Assembled

Back Next

All Together Now...

I assembled the cylinders with the cylinder heads, pistons, valves, etc.  This is what they looked like. 

I temporarily used bolts instead of studs/nuts so they wouldn't get bent during construction.  You may notice that the saddle looks a little strange.  The original saddle was too low, so I machined it off and am building another one to bolt on.

Back Next

#01 So It Began #2 Frame #3 Drivers #4 Quartering #5 Trucks #6 Frame & Wheels #7 Side Rods #8 Cylinder Boring #9 Cyl/Valve Liners #10 Cyl/Valve Cover #11 Pistons & Valves #12 Cyl Assembled #13 Boiler #14 Suspension #15 Crosshead #16 Brakes #17 Link Support #18 Bell #19 Crosshead (again) #20 Connecting Rod #21 Stationary Runner #22 Smokebox #23 Valve Gear #24 Running on Air #25 Piston Rings #26 Axle Pump #27 Plating #28 Lubrication #29 Blast Nozzle #30 Stack #31 Steam Turret #32 Burner Manifold #33 Mounting Brackets #34 Boiler Insulation #35 Jacketing #36 Cab #37 Throttle #38 Reverse Lever #39 Track Test #40 Smokebox Access #41 Electric Blower #42 Turbulators #43 Burner Test #44 Piping #45 Cab (part 2) #46 Inaugural Run #47 Post Steamup #48 Smokebox Lights #49 Running Boards #50 Pilot #51 Skirting #52 Paint #53 Lettering #54 Whistle #55 Skyline Casing #56 Fuel System Mods #57 Odds and Ends #58 Turbos

Home What's New Building the Daylight Daylight Tender Observation Car Engine Stand Gondolas Gauge Bell Ringer Air Pump Gas Switcher Taffy Puller

 

 

Questions or problems regarding this web site should be directed to [heydan "at" danslocoworks "dot" com].
Copyright 2017, 2018, 2019, 2020, 2021  [Dan's Loco Works]. All rights reserved.
Last modified: 03/02/2018.