Home What's New Building the Daylight Daylight Tender Observation Car Engine Stand Gondolas Gauge Bell Ringer Air Pump Gas Switcher Taffy Puller

#35 Jacketing

Back Next

Where's My Jacket?

Been making patterns for the boiler jacketing out of poster board.  I cut, then rolled the jacketing.  Even though I had all the holes laid out on the poster board, I thought it was best to make the cutouts AFTER I rolled the jacketing. 

 

After rolling, it took a lot of time lining up all the holes that were needed.

 

and primed...

Back Next

#01 So It Began #2 Frame #3 Drivers #4 Quartering #5 Trucks #6 Frame & Wheels #7 Side Rods #8 Cylinder Boring #9 Cyl/Valve Liners #10 Cyl/Valve Cover #11 Pistons & Valves #12 Cyl Assembled #13 Boiler #14 Suspension #15 Crosshead #16 Brakes #17 Link Support #18 Bell #19 Crosshead (again) #20 Connecting Rod #21 Stationary Runner #22 Smokebox #23 Valve Gear #24 Running on Air #25 Piston Rings #26 Axle Pump #27 Plating #28 Lubrication #29 Blast Nozzle #30 Stack #31 Steam Turret #32 Burner Manifold #33 Mounting Brackets #34 Boiler Insulation #35 Jacketing #36 Cab #37 Throttle #38 Reverse Lever #39 Track Test #40 Smokebox Access #41 Electric Blower #42 Turbulators #43 Burner Test #44 Piping #45 Cab (part 2) #46 Inaugural Run #47 Post Steamup #48 Smokebox Lights #49 Running Boards #50 Pilot #51 Skirting #52 Paint #53 Lettering #54 Whistle #55 Skyline Casing #56 Fuel System Mods #57 Odds and Ends #58 Turbos

Home What's New Building the Daylight Daylight Tender Observation Car Engine Stand Gondolas Gauge Bell Ringer Air Pump Gas Switcher Taffy Puller

 

 

Questions or problems regarding this web site should be directed to [heydan "at" danslocoworks "dot" com].
Copyright 2017, 2018, 2019, 2020, 2021  [Dan's Loco Works]. All rights reserved.
Last modified: 03/02/2018.