Nickel for Your
Thoughts?
Been doing a lot
of "detailing" for things that I didn't completely address when I first
made them. For example, I finally determined where all the grease
fittings were going to be to lube the rods and the type of zirks. I
ended up using the flush type zirks for appearance. Once I finished
prepping the rods and valve gear, I had them all nickel plated along
with some other parts. Here's some pictures...

Without...
and
With
bearings installed

Here's the bronze
bell that was made a while back.

And the valve
gear.

Here's a picture
of some of the bearings that came from all the rods and valve gear.
 |